DIY WOODEN LATHE | PART 1 | BED AND HEADSTOCK

Since I have my new drill press, the old one was standing unused in my workshop. So I decided to make a small wooden lathe out of it. The main parts i used to make this wooden lathe were the motor, the pulleys, the bearings, the belt and the power switch. In this video i make the bed of the lathe, the headstock and the drive shaft assembly. For plans and more, visit my website : www.isimplybuiltit.com ISBI ---------------------------------------------------------------------------------------------------------------- If you want to support my YouTube-Channel you can donate here : www.paypal.me/isimplybuiltit ---------------------------------------------------------------------------------------------------------------- FOLLOW ME ON INSTAGRAMM :   / i_simply_built_it   TWITTER :   / isimplybuiltit   PINTEREST https://www.pinterest.ch/isimplybuiltit/ FACEBOOK :   / isimplybuiltit   ------------------------------------------------------------------------------- #ISimplyBuiltIt #like #comment ------------------------------------------------------------------------------- DON'T TRY THIS AT HOME : I am a do-it-yourselfer and this is a private hobby video, by showing me how to solve special tasks! The video is not an instructional video and is not intended to be imitated! That's why : All information and tips without guarantee! Everyone is responsible for his actions and is responsible for his own mistakes! For all work, the general observe occupational health and safety regulations! I do not assume any liability for damages and injuries!