Yr11 Building and Construction - Cluster B Task Part 1/3 - Oil stone case (oil stone box)

50 minutes - Oilstone case part 1 Too long for students to watch, but a step-by-step. Eventually, I'll split this into parts that are 3-5 minutes. Yr11 Building and Construction - Building the Oil stone case (oil stone box) Part 1/3 0:00 Selecting your timber 0:20 Timber defects Testing for flat on the tablesaw Waney edge and loose knots In-wind and out of wind 1:42 Sharpening chisels with 2000# wet'n'dry, Melamine HMR particle board and a flying wedge. (students sharpen their own tools with this.) 5:48 Using a hand plane - flatten face 10:07 Plane Face Edge at 90 degrees to Face 13:40 Face marks and face edge marks 13:48 Setting a marking gauge - marking out thickness 15:40 FEWTEL 16:30 Plane other face to flat/out of wind 22:09 Set marking gauge to width - mark edge - rip off excess and plane to line 26:28 Layout of components 26:35 Mark out two components to length with marking knife 31:20 Layout recess/housing for stone on both sides. 34:09 Use Mortising Gauge to lay out stone - how to set up mortising gauge 36:35 Use chisel to cut out recess. Technique to chop out a recess - Hammer and Twist... 45:50 Paring with a chisel Use a shoulder to push the chisel into the timber - sharp chisels pare with shoulder pressure Part 1/3 -    • Yr11 Building and Construction - Cluster B...   Part 2/3 -    • Yr11 Building and Construction - Cluster B...   Part 3/3 -    • Yr11 Building and Construction - Cluster B...