DIY Light-Up Wand | Part 4 - Components

This video will finish up soldering on the rest of the electronic components. Please use caution when working with electronic tools and components. Here's the list of items. I included the link to the items to show what I bought, yet you don't need to get the exact same. These are Affiliate Links to Amazon. If I don't list a link next to them, it's something I picked up in an electronics supply shop like Fry's. Supplies: Chopstick (http://amzn.to/2hBAPTn) Wire 22-AG Solid Electrical tape Heat-shrink (optional) Resistor 150 Ohm (Part of pack, http://amzn.to/2yZAMHY) Button 6x6x4.5 (Not exact same, but very similar, http://amzn.to/2ygZLJq) Battery 4LR44 6V (http://amzn.to/2hC7GHK) LED (http://amzn.to/2xzoLru) Copper Clamps Solder Tools: Soldering Iron (http://amzn.to/2yh9qzE) Wire-strippers Needle nose pliers Soldering Mat (http://amzn.to/2hJ4J8e) Helping Hand (http://amzn.to/2kU9noQ) For decorating wands: Masking tape (or Painter's tape) Air Drying Clay (http://amzn.to/2z2Tnmn) Satin Acrylic Paint (can use other types, this worked for look I was going with) Optional Supplies: Heat-shrink (1", .5", 3/8") Twitter:   / stealthsharkinc   Facebook:   / stealthshark   Web: https://www.stealthshark.com/