Easy Hall Effect Transistor Ignition using a 3144 hall sensor and 2N2907 TIP42C Transistors

Here is a little electronic ignition that I made for a rotovator that has a dud magneto. it is based on the wiring diagram for the TIM 4 (I said TIM6 in the video in error) Which is a 12v adaptation of this jerry howell ignition: http://www.model-engine-plans.com/par.... I have not soldered a circuit board before so I found it a good task to learn on. it uses a TIP 42C transistor, a 2N 2907 transistor and a 3144 Hall effect sensor. All of these parts are available on Amazon, see links below. I used a standard 12v lucas ignition coil and a standard Lucas 12 v battery. This system will replace the points condenser ignition system in the Lucas SR1 Magneto that this engine had originally. I have made a wiring diagram to show you how it is laid out and a circuit board placement diagram too. I hope this helps you! Please like and subscribe!!! Thanks for watching. 3144 Hall sensor: https://amzn.to/32hympI If my videos have helped you out or if you appreciate them: please think about supporting the channel: Join this channel to get access to perks:    / @bootsowen   The best way to support this channel is by direct donation: buymeacoffee.com/Bootsowen Donate: paypal.me/bootsowen Support:   / bootsowen   Or you can buy something you were going to buy anyway through an affiliate link: Buy a VEVOR Magnet fishing kit! (Affiliate link) https://s.vevor.com/bfRa2s Or https://www.amazon.co.uk/shop/bootsowen I may receive a commission for the sale, it is usually very small, about 1% of the sale price. This has no effect on the price for you. The links used are affiliate links. As an Amazon Associate I earn from qualifying purchases. Thanks for watching my videos!