Wood turning - Scrap wood Pine

I was given just over a foot of scrap construction pine. So I cut it in 3 and glued it up (but forgot to film that bit!). The blank measured 11cm x 5.5cm, so roughly just over 4 x 2 inches. It had very wide grains, so I had to be very gentle with sharp tools when I turned it. I really liked that challenge to make a usable item from scrap wood. Thank you for watching. Bowl Sanding tool https://amzn.to/3vCe1dd Gouge Chisel Sharpening Jig https://amzn.to/3LU3sYZ Charnwood Lathe https://amzn.to/3KDnkxK Sanding Sealer https://amzn.to/3Fcp6EV …an absolute essential! WoodWax22 https://amzn.to/3F7pZig Gorilla Glue https://amzn.to/3s9LCt3 *If you shop through these links, I may receive a small commission. The price is the same for you, but it helps support me as a beginner woodturner in my quest to get a better lathe to make even bigger projects, and I really appreciate it! Note this is NOT an instructional video, or designed for any education purposes, it is simply my own personal steps on my wood turning journey. #pine #woodturning #rdmwoodturning