Detailed DIY - Drive Shaft and U-Joint Replacement 2015-2022 2nd Gen Chevy Colorado GMC Canyon

Remember to like and subscribe for more videos, and to help me continue making them! Amazon links to parts/tools I use, or similar, can be found below! (As available) Products/Parts: GM U-Joint Bracket: https://amzn.to/4u9n4NS GM U-Joint Pair: https://amzn.to/4flQXa4 Spicer U-Joint Pair: https://amzn.to/3RK2Gp5 Verify parts fitment for your specific vehicle. Tools: Carvalax U-Joint Ball Joint Press Kit: https://amzn.to/4fVdFWF Craftsman 1/2" Drive Ratchet: https://amzn.to/4o8jhPG Craftsman 22mm 1/2" Drive Socket: https://amzn.to/4uFUAMN Craftsman Ratcheting Wrench Set: https://amzn.to/4x241Yz Craftsman Screwdriver Set: https://amzn.to/4vsYg4B Craftsman Long Nose Pliers: https://amzn.to/4wTsVcG Craftsman Ball Peen Hammer: https://amzn.to/43ahFLq Gooseneck Pry Bar: https://amzn.to/4u9dsTi Irwin The Original Vice Grips: https://amzn.to/43GHeUv Titan Rubber Mallet: https://amzn.to/4dZba3d As an Amazon Associate I earn commissions from any qualifying purchases. 0:00 - Intro and Tools/Parts Used 3:28 - Notes and Prep for Drive Shaft Removal 4:49 - Remove Rear U-Joint Brackets 6:00 - Remove Drive Shaft 7:30 - Inspect Removed Parts 8:03 - Remove Front Yoke from Drive Shaft 8:46 - Press Old U-Joint from Driveshaft 11:16 - Install New U-Joint 14:06 - Reinstall Drive Shaft In this video I show how I removed and replaced the drive shaft and U-Joints on my 2018 Chevy Colorado Z71 4WD with the 3.6L V6. The video shows how I remove the drive shaft and the method I used to remove the U-Joints from the shaft. Sometimes vibrations or noises from under the truck can be caused by faulty U-Joints or an imbalanced or damaged drive shaft. If the U-Joints are faulty they must be replaced immediately as the driveshaft could seize and cause damage. I assume this method would be the same for all 2nd gen (2015-2022) Colorados and GMC Canyons, and maybe even all GM trucks with rear-wheel drive of similar years. Verify application for your vehicle. It wasn't pretty, but that's how I got it done. Hopefully you find this video helpful! Disclaimer: I am not a professional mechanic, nor do I claim to be. This video is for entertainment purposes only and shows how I accomplished the work. The methods and processes I used are not necessarily as outlined or recommended by GM. Always refer to GM/Chevrolet/GMC or your vehicle's manuals as explained and outlined by GM. I have not been endorsed by any of the companies or brands mentioned in this video. All opinions are entirely my own. I assume no liability for any damage or injury incurred by information in this video. Information to be used at your own risk. Due to factors beyond my control, no information in this video shall create any expressed or implied guarantee of any particular result. Injury, damage, or loss from improper use of tools, equipment, or information in this video is the viewer's responsibility.