How I fixed my Heatbed Issue (Bed Preheat Error) - Prusa i3 Mk3s

Hey guys! I recently had an issue with my heatbed not heating up properly, so in this video I will be giving a detailed description of my experience troubleshooting and then finally being able to fix my Prusa i3 Mk3s Printer. Prusa Help Articles: Full system refresh - https://help.prusa3d.com/article/full... Factory Reset - https://help.prusa3d.com/article/fact... Heatbed not heating up properly - https://help.prusa3d.com/article/heat... Preheat Error - https://help.prusa3d.com/article/preh... Images I used from Prusa's Help website: Image indicating location of thermistor wire on Einsy RAMBo Board - https://help.prusa3d.com/guide/how-to... Image I used to refer to the loose lock-nut and screw - https://help.prusa3d.com/guide/7-heat... Image of thermistor wire attached to bottom of heatbed with golden tape - https://help.prusa3d.com/article/heat... Image indicating where heatbed wires are attached to the board - https://help.prusa3d.com/article/mult... Music: Music track: familiar places by massobeats Source: https://freetouse.com/music No Copyright Vlog Music for Videos Music track: honey jam by massobeats Source: https://freetouse.com/music Free Music No Copyright (Safe) Music track: gingersweet by massobeats Source: https://freetouse.com/music Royalty Free Music for Video (Safe) 0:00 Intro 0:47 First stage of troubleshooting 2:11 Full System Refresh 3:58 Following troubleshooting steps of articles: Heatbed not Heating Properly, Preheat Error and Multimeter Usage 7:42 Consulting Prusa Support via Chat 10:58 Finding the Reason for the Issue 11:43 After Tightening the Screw, Calibrating the Printer, the Printer works! Byyyyyyye