The CYD EMULATOR You NEED | YellowB0i 3.5" ESP32 - S3

Build your own YellowB0i! What's going on folks! In this video, I assemble a 3.5″ ESP32-S3 Cheap Black Display. From the internal wiring to fitting everything inside the case, this is a hands-on look at bringing a YellowB0i build together the firmware linked below, you can turn a compatible DIY display into a handheld for retro games, converted movies, and optional NFC/RFID features. Want to support the DEVS? Custom L.E. printed cases are available from designer Zeek at ZeekSecLabs.com. We have a limited run of XOM and Zeek YellowBOi prints we think you guys will like! We appreciate your support, leave a boost on our maker world! If you don't want to solder, the only thing you'll need is a case and the speaker listed below. If your'e felling adventurous, the bill of materials is listed for you below. Solder Iron by FNIRSI FNIRSI HS-03 (Amazon): https://amzn.to/4erMbGw FNIRSI HS-03 (Official Website): https://fnirsi.top/4s8DoPD Materials required: FW - Yellowboi.us Freenove 3.5″ IPS CYD board https://a.co/d/04gv4vfa Printed shell and bezel https://makerworld.com/en/models/3466... FAT32 microSD card Awokdynamics.com Wire Harness Kit https://a.co/d/053mTVS5 8 ohm, 2 W speaker with a matching two-pin connector https://a.co/d/0eqqQs0T Battery sized to fit the case: https://a.co/d/0i9lFoKt https://a.co/d/00i6RNZz - 5v Boost Charging Module https://a.co/d/05fyPkQm - 3.3v Buck Converter https://a.co/d/0fs3cteJ - Switch Check the display-board variant and component dimensions before purchasing. Use the 3.5″ firmware for this build. Firmware flasher, movie converter, and setup guide: https://yellowboi.us by Xombi3 and Zeek