Custom-made 1990s-themed PVC Raincoat

Had this custom-made. My only criticism: not quite soft enough. I opted for 54 PHR as it was suggested (by AI) that 400 microns at around 50-54 PHR is a good all-rounder for both inflatables & raincoats. However, AI is not always consistent, as it later suggested that upping the PHR to 70, while keeping to 400 microns, will provide a very supple, very soft PVC that is good for both raincoats & inflatables. So, in my next custom run, I will opt for 70 PHR. DINP plasticizer was chosen (I do not like the 6P-free rubbish). It is just as well that I have access to GC-MS so that I can analyse a sample to confirm that the plasticizer is indeed DINP (as per my desired specifications), and to reassure myself that I have not been ripped off/conned with the 6P-free rubbish. Maybe the hood is a little too big. I might reduce it in my next custom project. No anti-block additives were added to the PVC resin, as I wanted to maximise the noise (rustle, crackle, squeak) caused by blocking. Increasing the PHR to 70 will maximise blocking even more.