Cara Convert iOS Cisco AP Lightweight to Autonomous Mode sebaliknya..

Tutorial How Step by Step Process Converting Cisco Aironet Access Point from Lightweight to Autonomous and Vice versa. Cara Convert iOS Cisco AP Lightweight to Autonomous Mode sebaliknya..(Autonomous ) seperti: SSID, VLAN, Band, Radio and till Internet Service. Requirements: 1.TFTPd64 Server 2.Cisco IOS Software ap3g1-k9w7-tar and ap3g1-k9w8-tar 3.The Cisco AP and the Laptop with TFTP server must be in same network. According to my network setup Lightweight AP BVI1 IP address is 192.168.1.5 Laptop's IP address where TFTP server is installed 192.168.1.2 [Default Router IP] Script Configurasi AP-Standalone: Noted: Kita buat 2 vlan vlan 10: non autnetikasi vlan 20: Autentikasi Enable Conf t Dot11 ssid IMC1 Vlan 10 Authentication open Mbssid Guest-mode exit Dot11 ssid IMC2 Vlan 20 authentication open authentication key-management wpa version 2 wpa-psk ascii 0 imcmantab Mbssid Guest-mode exit int dot11Radio 0 no shutdown mbssid ssid IMC1 encryption vlan 20 mode ciphers aes-ccm ssid IMC2 exi int dot11radio 0.10 encapsulation dot1q 10 bridge-group 2 exit int gigabitethernet0.10 encapsulation dot1q 10 bridge-group 2 exit int dot11radio 0.20 encapsulation dot1q 20 bridge-group 3 exit int gigabitethernet0.20 encapsulation dot1q 20 bridge-group 3 exit do show dot11 associations --------------------------------------------------------------------------------------------- Dibawah ini adalah Cara format dan upload image AP: formast flash: set IP_ADDR 192.168.1.5 set NETMASK 255.255.255.0 set DEFAULT_ROUTER 192.168.1.2 tftp_init ether_init flash_init tar -xtract tftp://192.168.1.2/ap3g1-k9w7-tar.153-3.JF9.tar flash: dir flash:/ set boot flash:/ap3g1-k9w7-mx.153-3.JF9/ap3g1-k9w7-mx.153-3.JF9 set boot