ULTREX REBUILD BOTTOM END

MINN KOTA Ultrex. This is a full description of how to rebuild the bottom and a typical MINN KOTA trolling motors with a armeture and shaft in the center over the armature housing. These new style Minnkota trolling motors separate on the right side where the bearing is located .., and also on the left side where the PROP is located and the brush assembly is located. I recommend purchasing extra parts because there will be times when a screw or bolt breaks off but this video shows how to fix and re-thread such problems. The required parts I suggest are below  Trolling motor minn Kota Ultrex, Ulterra and Terrova = same lower design Best parts and info resource below Also video includes Removing bearing trick using Grease Wet cardboard Bread Bar soap Hydraulic moves mountains I bought my parts here: https://lakesidemarineandservice.com/... If you have 4 1/2” diameter 36 V 112 lb thrust To save time from broken screws, through bolts and corroded parts I RECOMMEND BUYING; 1- 92-100-245 MINN KOTA 36 V 112 LB ARMATURE $100 1- NEW BRUSH END HOUSING #92-300-170 $30 1- BEARING FLANGE # 144-017 $5 2 pack THROUGH BOLTS # 830-095 $8 1- CABLE CLAMP # 230-038. (Nylon #2052510) 1- CABLE CLAMP SCREW (#6X3/8)# 2302104 1- MKP-10 1865012 MINN KOTA PROP NUT KIT (B 2262658, 2093100, 2091700) $7 1- BRUSH 4.5” SEAL KIT #2881450,188-095, 975-045, 9-738-011, 2053410. $36 And. Check out this awesome source; https://trollingmotorparts.com/