Coolant Replace and Flushing Procedures | Honda City | Tips and ideas |DIY

How to replace coolant and flush? Its Very simple and easy to understand. Caution: Wag gawin ang makina ng masyadong mainit, palamigin muna ito bago gawin! Mga kagamitan: *10mm l wrench or socket and rachet *Philip screw *Coolant/Eco cool *Distilled water/absolute *Funnel *Drain pan First step (removing coolant to the engine) cool down the engine *remove the splash guard *Release the pressure on the rad. Cap and retighten (if needed) *use drain pan and remove petcock *remove radiator cap *wait for the coolant to drain Second step (adding distilled water to flush the system) *reinstall petcock *use a funnel and Add distilled water *Squeeze rad. Hoses to remive air pockets *start the engine and wait until the radiator fan turn on(2x) *turn off the engine and reinstall radiator cap *Road test for about 10-15mins Third step ( Removing distilled water from the engine) *Release the pressure on the rad cap and retighten again. *Remove petcock *remove radiator cap *start the engine and accelerate the rpm slightly to remove some flushed coolant.(30 secs) *re install petcock *use funnel (add coolant to max) *Squeeze the rad. Hoses *wait until rad fan turns on (2x) *turn off the engine and check coolant *re install rad cap and add coolant from reserve. I hope may natutunan tayo sa video na ito! Thanks you so much guys!