OMTech | Installing a Lightburn Camera

I install a Lightburn Camera in my 80w OMTech laser engraver. I chose the 8MP (4K-W) in the 85-degree configuration based on the measurements that I took of my machine. This video only covers the installation of the camera, not the setup or calibration!! NOTE: ALWAYS use the Lightburn camera selection tool on the Lightburn website to confirm the correct camera for your specific machine. Camera: https://lightburnsoftware.com/product... Camera Mount: https://lightburnsoftware.com/collect... Cable Clips: https://www.amazon.com/dp/B08ZJF9W33?... USB Connector: https://www.amazon.com/dp/B07FT9MDX4?...