Makita Hedge Trimmer UH7580 DIY Diagnose and replace Damage spare parts

• Always be sure that the tool is switched off and unplugged before installing or removing chip receiver. • When replacing the chip receiver, always wear gloves so that hands and face does not directly contact the blade. Failure to do so may cause personal injury. • Always be sure to remove the blade cover before installing the chip receiver. • The chip receiver receives cut-off leaves and alleviates collecting thrown-away leaves. This can be installed on either side of the tool The blade cover (standard equipment) cannot be installed on the tool with the chip receiver being installed. Before carrying or storing, unin stall the chip receiver and then install the blade cover to avoid blade exposure. • Check the chip receiver for secure installment before use. • Never try to uninstall the chip receiver by an excessive force with its hooks locked in the blade unit grooves. Using the excessive force may damage it. MAINTENANCE • Always be sure that the tool is switched off and unplugged before attempting to perform inspec tion or maintenance. Cleaning the tool Clean out the tool by wiping off dust with a dry or soap dipped rag. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Blade maintenance Smear the blade before and once per hour during oper ation using machine oil or similars. After operation, remove dust from both sides of the blade with wired brush, wipe off it with a rag and then apply enough low-viscosity oil, such as machine oil etc. and spray-type lubricating oil. • Do not wash the blades in water. Failure to do so may cause rust or damage on the tool. -If the parts other than the shear blades such as the crank are worn out, ask Makita Authorized Service Centers for parts replacement or repairs. Removing or installing shear blade • Before removing or installing shear blade, always be sure that the tool is switched off and unplugged. • When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. Failure to do so may cause personal injury. • Do not wipe off grease from the gear and crank. Failure to do so may cause damage to the tool. • For specific way of removing and installing shear blades refer to the reverse of a package for accessory shear blades.