Fitting an Andreani Fork Cartridge Kit to an MT-07

This noob runs through the process of installing a fork cartridge kit on the Yamaha MT-07. Actually not too hard if you have the tools required! I kinda completely forgot to show removing the mudguard...perhaps because it was an absolute pain! Ah well. Other Useful Resources:    • Andreani USA - Andreani Cartridge "Misano ...   - David at Andreani USA explains how to set up the Misano Evo fork, this was very helpful. https://www.fz07.org/thread/14951/fz0... - this forum article was also handy. 00:00 Intro 00:05 Disclaimer 00:15 Loosen the Axle Bolt 01:05 Remove Caliper Bolts 01:34 Remove Mudguard Bolt 01:53 Zip Tie Calipers 02:09 Remove the Front Wheel 02:14 Loosen Fork Cap 02:26 Loosen Pinch Bolts 02:40 Remove Fork 02:53 Remove Fork Cap 03:18 Remove Dust Seal and Retaining Clip 03:48 Remove Lower Stanchion Bolt 04:00 Separate Fork Sections 04:37 Remove Inner Fork Bushing 04:50 Grind/Lathe the Stanchion 06:30 Remove the 'Reduction Bung'/'Hydraulic Lock'/Bushing 06:47 Fit the Inner Fork Bushing 07:01 Fit the Outer Fork Bushing and Washer 07:18 Slide the Oil Seal onto the Stanchion 08:45 Drive the Oil Seal into its Seat 09:05 Insert the Fork Cartridge 09:28 Fit the Fork Tube Bolt and Washer 09:34 Fit the Retaining Clip 09:52 Fit the Dust Seal 10:13 Torque the Fork Tube Bolt to 30Nm 10:28 Fill with Fork Oil 10:46 Bleed the Fork 11:03 Set the Oil height (120mm) 11:19 Set the Compression/Rebound - 'Phase 4' 11:59 Fit the Spring and Spacer 12:27 Compress the Spring 13:00 Fit the Fork Cap 13:59 Set the Preload 14:20 Reinstall the Fork 14:50 Refit the Front Wheel 15:12 Torque the Wheel Components/Brake Calipers/Pinch Bolts 15:20 Caliper Bolts are actually 40Nm! Torque Settings: Upper Pinch Bolts: 26Nm Lower Pinch Bolts: 23Nm Front Brake Caliper Bolts: 30NM Front Wheel Axle: 65Nm