Seplos V3 BMS Studio Guide (see description for updated settings)

The Seplos V3 BMS Studio full setup video is a step by step tutorial on where and how to download the studio software and everything else to connect the BMS to your computer for setup. NOTE: datalogger should be set to 9600 baud rate. SEE BELOW FOR MY LATEST SETTINGS. Setting shown in the video are too conservative and may cause batteries to not fully charge and balance, especially with more than one battery. I have updated the following parameters: Battery High Voltage Recovery = 56V Battery High Voltage Alarm = 56.8V Battery Over Voltage Recovery = 56V Battery Over Voltage Protection = 57.6V Cell High Voltage Recovery = 3.5V Cell High Voltage Alarm = 3.55V Cell Over Voltage Recovery = 3.5V Cell Over Voltage Protection = 3.6V Rated Battery Capacity = enter you cell Ah rating Total Battery Capacity = enter your cell Ah rating, or the actual capacity if degraded Links: RS485 Adapter https://www.amazon.co.uk/dp/B078X5H8H... RS485 Driver Software https://www.silabs.com/developers/usb... CAT6/RJ45 Ethernet cable https://www.amazon.co.uk/Mr-Tronic-Et... BMS Studio https://www.seplos.com/article-536714...