Lesson 1 of 50 Basic Introduction to Autocad For Mechanical Engineering

Lesson 1 of 50 - the complete AutoCAD course for mechanical engineering drawing. NEXT LESSON ► [cola aqui o link da Lesson 2] FULL 50-LESSON COURSE ► [cola aqui o link da playlist] In this first lesson we go through the AutoCAD 2018 interface, the panels and commands you will use throughout the course, how to set up your work area with LIMITS, and your first lines and circles. No previous experience needed. COMMANDS COVERED LIMITS · ZOOM ALL · LINE · ORTHO MODE · OBJECT SNAP (endpoint, midpoint, centre) · CIRCLE (radius and diameter) · ERASE · SAVE AS DWG 0:00 Intro - what this 50-lesson course covers 1:23 Opening AutoCAD and starting a new drawing 2:05 The interface - Draw, Modify, Annotation and Layers panels 2:43 Split commands - the small white arrow 3:13 The drawing area and the Grid (turning it on and off) 4:29 The command line, and using ESC to cancel 5:06 Why you set your drawing size first 6:26 LIMITS - setting up the work area 7:48 ZOOM ALL - applying the limits 8:02 The LINE command - first point and next point 9:02 ORTHO MODE - forcing straight lines 9:35 Drawing a line by length and angle 10:14 Closing a shape - the CLOSE option 11:42 OBJECT SNAP - endpoint 12:23 OBJECT SNAP - midpoint 13:14 The CIRCLE command - radius and diameter 13:56 A second circle on the same centre point 14:41 ERASE - three different ways 16:24 Saving as a DWG file, and opening it again 17:33 What comes in Lesson 2 Do not hesitate to comment and leave suggestions. www.mengineer10.com