CHEMetrics K-9400 Detergents Test Kit Demonstration

CHEMetrics® K-9400 Detergents Test Kits utilize the Methylene Blue Anionic Surfactant (MBAS) method. Test results are calibrated for ppm Linear Alkylbenzene Sulfonate (LAS). Follow this simple test procedure: · Rinse the reaction tube with the sample to be tested. (RINSE) · Fill it to the 5 mL mark with the sample. (FILL TO 5ML) · While holding the double-tipped ampoule in a vertical position, snap the upper tip using the tip breaking tool. (SNAP 1st TIP) · Invert the ampoule and position the open end over the reaction tube. (INVERT) · Snap the upper tip. (SNAP 2nd TIP) · Allow the contents to drain into the reaction tube. (DRAIN) · Cap the reaction tube and shake it vigorously 30 seconds to 1 minute. (SHAKE) · Allow the tube to stand undisturbed for 1 minute. (LET STAND) · Make sure the flexible tubing is firmly attached to the CHEMet ampoule tip and insert the CHEMet assembly (tubing first) into the reaction tube making sure that the end of the flexible tubing is at the bottom of the tube. (INSERT) · Break the tip of the CHEMet ampoule by gently pressing it against the side of the reaction tube. The ampoule should draw in fluid only from the organic phase (that is, the bottom layer). (SNAP) · When filling is complete, remove the CHEMet assembly from the reaction tube. (REMOVE) · Place a cap firmly onto the ampoule tip. (APPLY CAP) · Invert the ampoule several times, allowing the bubble to travel from end to end. (INVERT) · Place the ampoule, flat end first, into the comparator. Hold the comparator up toward a source of light and view from the bottom. (COMPARE) · Rotate the comparator until the best color match is found. (OBTAIN RESULT) Visit www.chemetrics.com or call (540) 788-9026 for more information. Count on us for Simplicity In Water Analysis.