Husqvarna 2000 sewing machine - Setting the raise of the cam follower

THE RAISE OF THE CAM FOLLOWER REQUIREMENTS Set the pattern selector knob for zigzag and the stitch length knob and width knob at 4. Turn the handwheel until the cam follower (11/37) reaches the highest point on a cam lobe. Then turn the stitch width knob to zero. In this position the cam follower should be raised 0.5 . 1.0 mm over the cam lobe. ADJUSTMENT Turn the eccentric screw (11164) until the required gap is obtained. The adjustment screw is friction loaded and may be turned in either direction. COMMENT This adjustment ensures that the stitch width cam follower will not be riding a cam lobe when the machine is set for straight sewing. Thus, no zigzag on a straight stitch. http://www.sewingnz.com/husqvarna-vik... NOTE On older style machines are adjusted differently.