Can 3 Different Batteries Run in One Parallel System? | POW-ECO-6KW

In this video, we demonstrate how to wire and configure three POW-ECO-6KW all-in-one solar inverters in a single-phase parallel system using different battery models. Each inverter connects to its own battery, so you can build a parallel system without replacing your existing batteries with identical models. ______________________________________________________________ ✅ WHAT'S COVERED IN THIS VIDEO: • Wall mounting with expansion screws • Connecting a different battery module to each inverter • AC grid input and AC output wiring (L1, L2, and shared N) • Home Load circuit and how excess PV power is delivered • PV wiring with dual MPPT inputs • BMS communication setup with DIP switch and RS485 cable • Parallel communication cable daisy chain • Grounding and CT installation for each inverter • Power-on sequence and parallel mode configuration with the PYLON protocol 📋 Quick Specs — POW-ECO-6KW Rated Power: 6000W System Voltage: 48V AC Input Voltage: 220V AC (Pure Sine Wave) Built-in MPPT Solar Charge Controller PV Array MPPT Voltage Range: 50～520V Parallel Capability: 6 Compatible Battery: LiFePO4 / Lead-Acid / AGM / Gel /Lithium Batteries ❓ Frequently Asked Questions: Q: Can POW-ECO-6KW inverters run in parallel with different battery models? A: Yes. Each inverter connects to its own battery module, so the batteries do not have to be identical. For best overall performance, use batteries with the same or similar capacity. Q: How do I set up BMS communication on the POW-ECO-6KW? A: Set the battery DIP switch to 1, then connect the battery's RS485 BMS port to the inverter's BMS port with a standard network cable. For PowMr batteries, select the PYLON protocol in the Battery Type setting. Q: How do I enable parallel mode on the POW-ECO-6KW? A: Go to Working Mode and change Parallel Mode to Parallel. Turn off the inverter switch before saving, then press Save before the display turns off. Repeat for each inverter, then power them on one by one. The master unit shows a master icon on the home screen. Q: How do I install the CT on a POW-ECO-6KW parallel system? A: Plug the CT into the inverter's CT port and clamp it around the live wire between the utility-side breaker and the utility connection, with the arrow pointing toward the grid. Each inverter needs its own CT installed at the same location. ______________________________________________________________ More Info 👇 POW-ECO-6KW https://tinyurl.com/kfm6prnu Email: support@powmr.com 👇 Related Videos: 1. POW-ECO-6KW Off-Grid Inverter — Brand New, Fully Loaded    • POW-ECO-6KW Inverter Unboxing: Power Your ...   2. How to Wire the POW-ECO-6KW Inverter Correctly    • How to Wire the POW-ECO-6KW Inverter Corre...   3. POW-ECO-6KW Display Guide: How to Navigate Settings & Menus    • POW-ECO-6KW Display Guide: How to Navigate...