How to Install Works Bell Hub & Rapfix GTC & Renown Steering Wheel on a NSX (Full DIY)

This is a DIY on how to install a Works Bell Short Hub (Honda 290S), Works Bell Rapfix GTC-R flip up hub & a Renown USA steering wheel on a 91-05 Honda/Acura NSX. This is a very straight forward install and my personally recommended hub setup vs the OEM MOMO hub that I installed on a previous video. Because it retains the OEM SRS reel, the install time is cut significantly over the OEM MOMO setup. The Works Bell hub and flip up adapter come with everything needed to install as well as keep the SRS light off and keep the horn working as it should. Like all of my DIY videos, I recommend watching the video in it's entirety before attempting installation and always take the proper safety precautions when working with automotive SRS components. I give this DIY a difficulty rating of: 5 out of 10. Care must be taken when working with SRS airbags! Other than that, special tools help make this job MUCH easier, such as the rubber strap wrench to hold the hub and dremel to cut down the ground wire tab. It is not a hard job, but sometimes the OEM steering wheel can get stuck on and requires a lot of force to remove and arranging the plugs in the hub can be annoying. *Difficulty Rating Scale Explanation: I rate my DIYs on a scale of 1-10. 1 requiring minimal effort and little to no tools, such as installing wiper blades replacements. 10 requiring extensive time/effort and requiring many special tools, such as assembling an engine or transmission. Parts Used in this video: Works Bell Short Hub: Honda 290S model Works Bell Rapfix GTC Hybrid flip up hub Renown USA Champion Steering Wheel Tools Required: 19mm Socket + extension Torque wrench capable of 36 ft*lbs Torx bits Optional Tools: Rubber Strap Wrench: https://amzn.to/3SWyPrD Dremel w/sanding drum or file (to file down grounding wire tab) 0:00 - Intro 0:59 - Removing Factory Steering Wheel 4:15 - SRS Reel & Works Bell Hub 6:34 - SRS Light Defeat & Horn wiring 7:55 - Installing the Works Bell Short Hub 8:51 - Torquing the Hub Nut 9:04 - Tucking Away Wiring & Installing the Flip Up Adapter 12:18 - Modifying the Grounding Wire 13:04 - Installing the Horn Button 13:45 - Final Thoughts 15:02 - Photos +As an Amazon Associate I earn from qualifying purchases. Instagram:   / chrislumnsx   Facebook:   / chrislumnsx   #NSX #acura #honda