How to Install a Filter Tower on Your Nardi Pacific Compressor | Nardi Compressori

Learn how to install a filter tower on your new Nardi Pacific compressor with Brett Chittenden of Nardi Compressori Dubai. This step-by-step how-to covers unpacking, checking the threads, threading the tower onto the filter base, inserting the filter, and sealing the lid. What you’ll see: • What comes in the package: filter tower, lid, O-ring, and spacer O-ring • How to check the threads for dirt or damage before installing • How to thread the tower onto the filter base (clockwise, with the sticker facing forward) • How to insert the filter element with the nipple ends facing down • How to close the lid for a metal-to-metal seal • A service tip: tighten fully, then back the lid off a fraction so it is easy to open later Handle the lid carefully when opening the tower. The O-ring and spacer O-ring sit under it. Chapters 0:00 Introduction 0:13 What’s in the package 0:30 Checking the threads 0:37 Threading the tower onto the filter base 1:36 Inserting the filter element 2:35 Tightening the lid and backing off a fraction Part of the Nardi “How To” Series from Nardi Americas. Questions? In the Americas, visit https://www.nardiamericas.shop Worldwide, visit https://www.nardicompressori.com