Knuckle Kit

In this installation video, we install the CA Tech USA Maverick R Big Knuckle Kit on a Can-Am Maverick R. The installation covers removing the factory front suspension components, installing the new upper and lower control arms, transferring the brake rotor, installing the billet knuckle, reconnecting the suspension, and completing final assembly. The Big Knuckle Kit is designed to improve front suspension geometry while providing a strong, purpose-built setup for demanding off-road use. ----------------------------------------------------------------------------------------------------------------- ⚠️ Disclaimer This video covers the knuckle and control arm installation. For the tie rod installation, watch the separate video linked below. ----------------------------------------------------------------------------------------------------------------- Tie Rod Installation Video:    • Can-Am Maverick R Tie Rod & Steering Flag ...   ----------------------------------------------------------------------------------------------------------------- Shop the Maverick R Big Knuckle Kit: https://catechusa.com/products/maveri... ----------------------------------------------------------------------------------------------------------------- Installation Timestamps 00:00 – Introduction 00:12 – Tools Required 00:24 – Disclaimer / Tie Rod Video 00:29 – Remove Brake Caliper 00:50 – Remove Tie Rod 01:01 – Disconnect Upper Control Arm from Knuckle 01:11 – Disconnect Lower Control Arm from Knuckle 01:19 – Remove Coilover 01:37 – Remove Upper Control Arm 01:54 – Remove Sway Bar Link 02:07 – Remove Brake Lines 02:26 – Remove Lower Control Arm 02:52 – Install New Lower Control Arm 03:13 – Install New Upper Control Arm 03:30 – Reattach Coilover 03:49 – Transfer Rotor to New Knuckle 04:36 – Install New Knuckle 05:04 – Reattach Tie Rod 05:27 – Attach Axle Total Video Length: 07:18 ----------------------------------------------------------------------------------------------------------------- Torque Specs Knuckle Mounting Bolts: 111 ft-lbs with threadlocker ----------------------------------------------------------------------------------------------------------------- Tools Required 15mm socket and wrench 18mm socket 19mm socket and wrench 21mm socket 30mm socket ----------------------------------------------------------------------------------------------------------------- Installation Note: Route the brake line over the top of the lower control arm rather than underneath it. #madeintheusa #canammaverick #maverickr #canam #sidebyside #sxs #offroad #installation