Huztl / Stihl ms660 clone bolt for bolt part 1!!! unboxing and crankcase

If you are looking for aftermarket chainsaw parts, please support my channel by buying from these guys http://www.hlsproparts.com/?Click=48376 Disclaimer: ladies and gents, this is a CHAINSAW, working with, building and fiddling with these can KILL YOU, I am not and will not be responsible for improper technique or accidents even remotely relating to this video, please view for entertainment purposes only. Look up Huztl.net for the saw kits themselves This is part 1 of the ms660 clone bolt for bolt assembly series My creation of the crank puller tools:    • Husqvarna Stihl crank/bearing installation...   Other things I use here in this vid: oem gasket kit 1122-007-1053 Threebond 1184 sealant Blue loctite m10x1.0 RH tap (or 1/8"npt) and 3/4" threaded rod ideally: m12x1.0 LH tap and 3/4" threaded rod (for PTO) bgchemtool or acetone aftermarket scrench (or any other round cheap metal that fits) ...ideal OD around .800 (less than .875") and length .75" or so This is the first in the series. I will take this saw to fully built, as well as others including husqvarna 372 clone, and stihl's ms440 and 360's. UPDATE: As Walt points out, its important to make sure the case positioning pins are inserted in the FLYWHEEL SIDE case half... insert the pins in that case half, put the gasket over that, then put the cases together. Best way to support my channel is to click on the link above for HL supply when you need aftermarket parts for your saws.