Van Plumbing 101: How to Build a Complete Water System | GoCode

Learn how to plumb a camper van from start to finish. Luke walks through a full van water system on a tabletop: mounting tanks, drilling ports, crimping PEX, connecting hoses, and wiring and plumbing your components into one working system. GoCode products used in this video: Wheel Well Tank (SP-R-22): https://gocodeoverland.com/collection... KUS Water Level Sensor: https://gocodeoverland.com/products/p... Tank Heating Pad: https://gocodeoverland.com/products/f... Tank Mounting Brackets and Straps: https://gocodeoverland.com/collection... Pundmann 6L Water Heater: https://gocodeoverland.com/collection... Shower Port: https://gocodeoverland.com/products/s... FOLD Shower: https://gocodeoverland.com/collection... Other materials and tools used: Blue Monster tape: https://a.co/d/05xGVAwm PEX crimp fittings: https://a.co/d/07k8fHN0 Pex clips: https://a.co/d/00VF9QX0 PEX crimp and cutting tool kit: https://a.co/d/02941eVY PVC hose: https://a.co/d/07KLXN8c Various PEX fittings used. Chapters: 0:45 Drill out the port and install the KUS sensor 2:08 Install the fill, vent, and drain fittings 4:02 Install the tank heating pad 4:42 Install the inlet port and crimp PEX 6:19 Pre-plumb on the desk: fill, vent, and drain stubs 7:39 Lay out the top board: heater, pump, and trunk lines 12:51 Test fit the plumbing layout 16:39 Mount the board and standoffs 18:06 Hook up the water heater with shut-off valves 21:09 Mount the tank brackets and straps 23:40 Plumb the tank vent and drain 25:35 Hook up the shower port 26:06 Wire the pump and heater pad switches 26:28 Full system walkthrough and gray tank drain 28:00 Wrap-up and fitting options