Diabolical Slipstream Install | Lockable Ford Bronco Security Enclosure

Lock down your Bronco's cargo area for top-off, doors-off days. In this full install, we put the Diabolical Inc Slipstream Security Enclosure into a 4-door Ford Bronco using only the MOTLEY Ford Performance Tool Kit and a 7/16" bit, out in the woods, in about two hours. ► GET THE RAPTOR NATION × DIABOLICAL SLIPSTREAM BUNDLE: https://shop.diabolicalinc.com/products/ra... THE BUNDLE Raptor Nation teamed up with Diabolical Inc to build a Slipstream bundle for our community. WHAT'S INCLUDED: Slipstream Security Enclosure + Folding Top MOLLE Panels + Custom Raptor Nation CNC-Engraved Marine Deck Mats . Not a member yet? Join Raptor Nation and unlock partner pricing: https://fordraptornation.com/products/rapt... WHY THE SLIPSTREAM Full-coverage, lockable enclosure for the 4-door Bronco's rear cargo area Powder-coated steel frame with an aluminum case Hinged, latching lid with adjustable tension, plus tie-down points on top Foam-lined and edge-sealed for a snug, rattle-free fit Bolts in at the factory mounting points using the factory hardware Works with the rear seats up. We installed it with car seats in the back. Clears the tailgate when it's closed Keeps your gear locked up when the top and doors come off WHAT YOU'LL NEED Diabolical Slipstream Security Enclosure (6th Gen Bronco 4-Door) Tool Kit (MOTLEY Ford Performance Tool Kit worked for Austin) 7/16" bit About 2 hours INSTALL TIPS FROM THIS BUILD Leave the back wall, brackets and rails loose until everything is centered, then tighten. Use pieces of cardboard as spacers to check for even gaps around the door. Don't over-tighten the small hinge nuts. They can snap. Start with three shims on the latch bracket and adjust tension from there. If it rains mid-install (it did for us), dry the panels before fitting the seals. CHAPTERS 0:00 Slipstream install using only the MOTLEY toolkit 0:26 Remove factory tie-down hooks & mount side brackets 0:51 Install the back wall (leave loose to center) 1:38 Side cover panels & foam 2:17 Assemble the side brackets 3:04 Fit the precut rubber strips 3:32 Mount the long rails 4:21 Install the side rails (gap faces forward) 5:14 Top skins & tie-downs 5:55 Foam the rear opening 6:25 Door lock assembly & magnet 6:58 Attach the door hinges 7:29 Pin the door & check spacing 8:28 Build the top panels 9:05 Attach the top & run the seal 9:22 Set the lid & adjust latch shims 10:09 Tailgate clearance check 10:26 Final brackets & finished install LINKS ► Raptor Nation × Diabolical Slipstream Bundle: https://shop.diabolicalinc.com/products/ra... ► Join Raptor Nation: https://fordraptornation.com/products/rapt... ► Raptor Nation: https://fordraptornation.com ► Diabolical Inc: https://shop.diabolicalinc.com ► Instagram: https://www.instagram.com/thefordraptornation Installed by Austin Gillis. #FordBronco #RaptorNation #BroncoAccessories