Vedio What To Do If Your Laptop Is Plugged In But Not Charging ..2 simple Ways to FIX Battery

God bless you #battery_not_charging #Translated_video #0%_available_plugged_in,_not_charging We talked in a previous video about recovering a #stopped_charging #laptop_battery Today we will use the easiest method and materials available to restore a #damaged_battery This laptop has not been used for a while and the battery has #stopped_charging It took us over an hour to charge the battery But it remained at 0%. After another 10 minutes it's still 0%. The laptop battery stops working sometimes due to not being used for a period of time In the previous video, we used a more powerful charger than the original laptop charger Meaning if the original charger was 3 ampere, for example, we will use a charger greater than 4 ampere We can use a 10A charger if available without fear Taking into account the stability of the voltage used in the original charger Meaning using a charger with the same voltage, but with a greater ampere capacity as much as possible and available And now we have a question. What happened when we did not use the laptop for a period of time? Why did the #battery_fail? Simply because it's a #lithium-ion_battery It gives us a voltage of 3.7 and has two properties when charged and when discharged When recharging, you should stop when it is 4.2 volts More than that is called over charging and it leads to a change in the internal resistance and damage to the battery And when the battery is discharged, we must stop drawing at about 2.6 volts Going down the voltages more than this is called over des charging The lithium battery has another property called self-loss 2-4% If we stop using it for a while, it will lose its charge automatically If it falls below the threshold called over des charging, it will be damaged and will not work again Now we will #simply_fix_it We will remove the battery and take off the outer cover We can use some benzene to make loosening, but it will affect the plastic The cells are connected in series to give the total voltage At both ends there is a positive pole and a negative pole We will provide an external source of electricity with a voltage of 12 volts and a suitable ampere We can use power of the desktop computer The black wire with the yellow wire gives us a good voltage of 12 volts and amperes We connect the negative pole to the negative terminal and the positive pole - yellow - to the negative terminal Leave it on for about 10 minutes Then we disconnect the electricity and re-install the battery Then we test the laptop to see if the situation changes Now the battery has charged 1%. We have succeeded We leave the laptop in charge to check if it will complete the charging Now the battery has been charged 7% Now I have a question Why did you turn off the laptop while charging? Simply because it is the best way to charge the battery The best battery charge while the laptop is off Now, after about two hours, the battery is 100%. We have finished the work now We have succeeded may God give you happiness