Toyota land cruiser all key lost
ADDAUTOKEYZ
0:00 / 0:00
Toyota land cruiser all key lost
4 972 просмотра · 1 год назад
ADDAUTOKEYZ
3,65 тыс. подписчиков
4 972 просмотра · 1 год назад
TOYOTA LAND CRUISER KEY PROGRAMMING WITH TANGO & VVDI PROG
✅ What You’ll Need:
Tool/Item Purpose
VVDI Prog To read/write EEPROM data
Tango Programmer To generate a working key from dump
New Smart Key OEM or aftermarket, compatible type
Access to Smart ECU Usually inside dashboard
Soldering tools For reading/writing the chip
🔍 STEP-BY-STEP GUIDE
🔹 Step 1: Remove and Identify the Smart ECU
Located under the dashboard (passenger side, behind glove box or center stack).
Mark down the part number (needed for selecting correct memory layout).
Open the ECU carefully without damaging the PCB.
🔹 Step 2: Read the EEPROM Using VVDI Prog
Locate EEPROM Chip
Common chip types: 93C86, 93C66, 24C02, etc.
Find the correct chip using a datasheet or identifier.
Connect VVDI Prog
Use the correct clip or solder directly to the chip.
Select the correct chip type in VVDI Prog software.
Read & Save the EEPROM Dump
Save it as original.bin or similar.
Create a backup before any modification.
🔹 Step 3: Load EEPROM Dump into Tango
Open Tango Software
Select Toyota → Land Cruiser → Smart Key
Load the EEPROM dump
Analyze the key slots
Tango will show:
Master key slots
Used/empty slots
Generate a New Key
Insert a blank transponder (e.g., Toyota 4D or 80-bit key depending on your model).
Write the new key to the blank chip.
Save a modified EEPROM dump with new key added.
🔹 Step 4: Write Back Modified Dump to EEPROM
Use VVDI Prog again.
Load the modified dump from Tango.
Write it to the same EEPROM chip.
Verify the write was successful.
🔹 Step 5: Reassemble & Test
Reinstall Smart ECU into the vehicle.
Insert or approach with the new key:
If the process was successful, the car should:
Recognize the key.
Enable ignition/start button.
Test all key functions (lock/unlock/start).
🧠 Important Notes:
Some ECUs (especially post-2013) may have encrypted EEPROMs or linked ID code boxes — if so, you may need to reset the ID box as well.
Always back up original data before modification.
If using an emulator (like LKP-04 or similar), you can bypass testing with a real key at first.