Attaching a coaxial connector WITHOUT special tools!

Stuff you will need... 1 scrap 2x4 board about a foot long 2 scrap 2x4s 4 inches to foot long (They are used to raise the foot long board off the table.) 1 scrap 1x4, 3 to 5 inches long 1/2 in. drill bit 1/8 in. drill bit Three 1/4 in. washers Three 7/16 in. washers Three #10 wood screws 1 inch long compression type coaxial connectors (bought mine off of amazon) coaxial cable (I used old cable that Dish left behind when we canceled our service years ago) drill side cutters, heavy duty scissors, or a sharp knife ruler Screwdriver for wood screws If you are looking for an even quicker method than check this video out.    • Attaching a coaxial connector WITHOUT spec...   Disclaimer: All products used in this video were purchased by me and all video content is my own and has been edited by me, Matthew Fox. Note: Filmed using a Samsung WB250F