iPhone 11 Keeps Restarting - When the "Typical" Issues are NOT the Problem.

Case category: Water Damage Failure type: 3-minute reboot / PRSO panic log caused by water-damaged resistors Actual billed price: Standard Recovery ($750) Start your water-damaged iPhone data recovery here: https://www.iboardrepair.com/water-da... In this video I show an iPhone 11 that is stuck with a 3 minute reboot. Specifically, I am seeing "missing sensor: prs0" in the panic log. Most commonly, this issue is resolved by changing the charging port. More rarely, you may find that you have bad resistors around the charging port. Even more rarely, you may have to change either your audio codec IC or your audio amp IC. In this case, none of these were the problem. This was a water damaged device in for data recovery. When the common solutions do not work, you must look elsewhere. With water damage, you have the luxury of being able to see what components look bad and corroded. When you see ANY resistors that are corroded, that are always worth taking a look at schematics to see if they appear important or not. Watch this video to see one of the more rare causes of iPhone 11 with a 3 minute reboot with a prs0 error. 00:00 iPhone 11 Keeps Restarting After Water Damage 00:49 Confirming the 3-Minute Reboot 01:50 Panic Log Review in 3uTools 02:46 PRSO Error: Why It Was Not the Charge Port 03:57 Water Damage Short Near NAND 05:15 Known-Good Charge Port but Still Rebooting 06:47 Corrosion Found Near the Camera Connector 07:50 Missing Resistors Traced in Boardview 10:24 Pulling Donor Resistors From an iPhone 11 Pro 12:28 Installing the First Replacement Resistor 17:19 Finding and Installing the Second Resistor 20:35 Phone Stays On Past 3 Minutes 21:36 Why Corroded Resistors Should Never Be Ignored