13) Preparazione e piegatura delle controfasce

Indice dei video : http://davidesora.altervista.org/vide... ENGLISH TRANSLATION of the written notes in the video, in order of appearance : 00:04 - Preparing and bending the linings 00:13 - Prepare a willow board bringing it to a uniform thickness of 2 mm 00:53 - Straighten one side following the pattern of the grain 01:19 - Use a piece of scrap lining to set the measure on the markind gauge (about 8 mm) 01:40 - Incise the two sides of the board for easily and efficiently cut off strips of the right size 02:13 - Re-plane every time the side where the marking gauge rests, obtaining all the necessary stripes 02:56 - Cut four strips at least 17 cm long for the linings of the lower bout 03:17 - Cut eight strips at least 12.5 cm long for the linings of the C and upper bout 03:58- Use a thin bladed knife and a 1.8 mm wide chisel to make the slots for the linings of the C 04:13 - Cut to a depth of 7.5 mm scarce 05:03 - Make an accurate fit but not forced, making sure that the lining get in and out of its slot freely without jamming, providing for the wood swelling when gluing 05:18 - Too much forced 05:47 - Ok 07:19 - Check the temperature of the bending iron 07:29 - Moisten with water 07:41 - Bend the linings so that they fit well with the curves of the ribs without too much tension 08:23 - Cut to measure with a chisel 08:51 - Remove inside corners to facilitate the insertion during gluing 11:42 - Upper bout linings 13:20 - Lower bout linings 14:39 - Cut the ends of the linings with the proper angle so that they fit well with blocks 15:26 - http://www.davidesora.it/ Index of videos : http://davidesora.altervista.org/vide... .