2007–2011 BMW 3 Series (E90) Driver Fender Removal & Installation | DIY Guide

Hey guys, Rolando from ReveMoto here. In this video I'm going to show you how to remove and install the driver-side fender on a 2007-2011 BMW 3 Series (E90). This is a longer one, about 30 minutes, because we'll take off the wheel, pull the fender liner, track down all the hidden bolts, disconnect the turn signal, and then install a pre-painted replacement with the right alignment. Stick with me. Go ahead and let's get started. Shop pre-painted BMW 3 Series fenders: https://www.revemoto.com/collections/... TIMESTAMPS: 0:00 - Intro and taping off adjacent panels 0:57 - Loosening lug nuts before jacking up 1:34 - Jack up car and remove wheel 2:06 - Removing fender liner push pins 3:26 - Removing fender liner bolts: 8mm starting from left 3:36 - Removing 10mm bolts and Torx fasteners behind liner 7:35 - Accessing and removing inner fender bolts 8:32 - Removing bumper attachment bolt 9:04 - Removing cap and fender liner 10:20 - Removing bolts inside fender: front bolt and rear bolt with extension 14:00 - Disconnecting turn signal wiring plug 15:05 - Removing top fender bolts (4 total) 19:45 - Final check and removing plastic rivets underneath 22:55 - Fender off - transfer accessories to new fender 26:00 - Installing new fender: push pin first, then top bolts 28:55 - Aligning gaps, tightening all bolts 30:30 - Reinstalling liner, push pins, and wheel 31:05 - Final alignment check and outro TOOLS USED IN THIS VIDEO: 8mm socket 10mm socket and ratchet with extension Torx bit set Jack and jack stands (to lift the car) Lug wrench (to remove wheel) Painter's tape (to protect adjacent panels) COMMON QUESTIONS (from viewer comments): Q: Can you show how to replace a rocker panel or skirt on the same car? A: Rocker panels are a different animal than a fender. They're usually clipped, screwed, and sometimes bonded on. If yours is just loose, check underneath for missing screws or broken clips first. ReveMoto can make a separate video covering that if needed, but we need to get another one in our shop first. COMPATIBLE VEHICLES: 2007 BMW 3 Series (E90 Sedan, E91 Wagon, E92 Coupe, E93 Convertible) 2008 BMW 3 Series (all E90-generation body styles) 2009 BMW 3 Series (all E90-generation body styles) 2010 BMW 3 Series (all E90-generation body styles) 2011 BMW 3 Series (all E90-generation body styles) ABOUT REVEMOTO: At ReveMoto, we paint bumpers, fenders, hoods, side mirrors, and a whole lot more to match your exact factory color. We're based out of Houston, Texas, and we ship to all 50 states. Every part comes ready to install with a lifetime paint warranty. If you guys need any pre-painted parts for your vehicle, head over to ReveMoto.com and we got you. ORDER YOUR PART: https://www.revemoto.com FOLLOW REVEMOTO: Instagram:   / revemoto   TikTok:   / revemoto   Facebook:   / revemoto   #BMW3Series #BMWFender #E90 #FenderReplacement #BMWDIY #ReveMoto #PrePaintedParts ______________________________________ DISCLAIMER: This video is for informational and educational purposes only and does not replace professional advice or certified repair service. ReveMoto makes no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. Tool sizes, fastener specs, and procedures can vary between trim levels and model year updates, so always verify against your vehicle's service manual before starting. All DIY projects carry risk, including injury, vehicle or property damage, and voiding of warranties. The viewer assumes all risk. If you are not comfortable with any step, stop and consult a licensed professional. ReveMoto is not responsible or liable for any loss, damage, injury, or claim resulting from the use of information in this video or from any tools, parts, or products shown. Third-party tools or brands mentioned are for reference only and are not endorsements. Pre-painted parts from ReveMoto.com are covered by their own warranty and return policy at www.ReveMoto.com.