Building a Boosted Classic Mini Engine - Part 3

#boosted #classicmini #engine ❱ Patreon -   / classicminidiy   ❱ Shop - https://merch.classicminidiy.com ❱ Seven Mini Parts - http://bit.ly/7evenmini ❱ Instagram -   / classicminidiy59   ❱ Facebook -   / classicminidiy   0:00 Intro 1:55 Primary Gear Install 3:45 Transfer Case Install 4:47 Primary Gear Seal Install 9:15 RTS Clutch Installation 12:15 Fan Pulley Install 14:32 Water Pump Install 15:26 Radiator Install 16:19 Clutch Cover(wok) Install 17:00 Outro ❱❱ Parts in this Episode: Tell him Classic Mini DIY sent you! RTS Clutch Setup:   / turbo_mk1_mini   Oversized Pulley: https://cmdiy.co/AlloyPulley Rear Main Seal Tool: https://cmdiy.co/RearMainInstaller Rear Main Seal: https://cmdiy.co/RearMain Main Seal Cover: https://cmdiy.co/DustCover Flywheel Locking Tool: https://cmdiy.co/FlywheelLockingTool Flywheel Bolt: https://cmdiy.co/VertoFlywheelBolt Flywheel lock tab: https://cmdiy.co/FlywheelLockTab Thanks for watching Classic Mini DIY! Please note Classic Mini DIY assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Classic Mini DIY recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, expensive electronics, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Classic Mini DIY, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Classic Mini DIY. Only attempt your own repairs if you can accept personal responsibility for the results, whether they are good or bad.