Triumph TR3 Accelerator Pedal Fix

A short video showing what I did to fix my accelerator pedal. The roll pin connecting the arm to the shaft was broken. From looking at the forums, others have commented that this roll pin gets rusty and breaks, so it's not unusual. I found some time this week to fix it. Had to take out the pedal, which was a bit tricky. Then had to take out that roll pin, again a bit tricky but easy with the extractor tool. Finally, had to put in a new roll pin, which required some clamping down with a vice grip to get it started, and a hammer to knock it down in there. Then install it back into the car, but didn't get the bottom screw in there because I lost it. And finally, test drive and final adjustments. The roll pin measures 1/8 by 3/4 inch, and the extractor tool is 1/8 inch.