K2 Improvements Cartographer Install Walkthrough

Complete K2 Plus Cartographer installation and setup walkthrough using K2-Improvements. Important: This walkthrough is based on the Rcpilot33 K2-Improvements menu and installer setup shown in these videos. Other K2-Improvements forks or versions may have different menu options, install paths, or behavior. If you are following this walkthrough, use the K2-Improvements repository linked below. This video covers the full process from gathering the required information through installing K2-Improvements, flashing Cartographer firmware, mounting the hardware, completing the software setup, configuring Fluidd, running Scan and Touch calibration, setting up the slicer, and establishing the global Z offset with the first print. Individual chapter videos are also available in the K2-Improvements - Cartographer Install & Setup playlist. Chapters: 00:00 Introduction 00:05 010 Gather Information 01:59 020 Set Up MobaXterm 03:35 030 Backup and Wipe the K2 Plus 04:54 040 Initial Setup and Self-Check 06:55 050 Run the K2 Improvements Bootstrap Installer 08:28 060 Menu Walkthrough 12:07 065 Flash Cartographer Firmware 13:42 067 Cartographer DFU Flash Recovery 16:37 070 Mount Cartographer 17:52 075 Cartographer Install Path 21:14 080 Fluidd Walkthrough 26:17 085 Setup After Cartographer Install 32:43 090 Cartographer Scan Calibration 38:41 100 Cartographer Touch Calibration 44:19 105 Slicer Material Pass Setup 46:22 110 First Print / Global Z Offset K2-Improvements GitHub: https://github.com/Rcpilot33/k2-impro... Discord:   / discord