Jeep Pneumatic Sway Bar Disconnect Install - Months in the making…

Thank you for tuning in! In this video I take a Rubicon sway bar with electronic disconnect and I install a pneumatic actuator on it and install in in my Jeep JK Sahara. I started filming this in my basement in February when it was -35C outside. It was some of the first videos I made so bare with me. Then it jumps to after I have the compressor installed. It took so long because the company I ordered it from said they had it in stock but didn't so I waited for shipping. I should have cancelled and gone to 4 Wheel Parts found out later they had it in stock. Oh'well. Here is the break down of parts I used. Sway Bar - bought used off of a guy that contacted me after I posted in the Edmonton Jeep Facebook page. Team Tech Offroad Pneumatic Rubicon sway bar disconnect https://teamtechoffroad.com/products/... ARB Compressor - https://www.4wheelparts.ca/p/arb-high... Auxbeam Switch Panel - https://www.amazon.ca/Auxbeam-Automat... 1/8" PT Male Push in Joint Pneumatic connectors - https://www.amazon.ca/Pneumatic-Conne... 1/4" PT Male Push in Joint Pneumatic Connectors - https://www.amazon.ca/Connect-Fitting... 40 Pcs Plastic Quick Fitting 6mm Pneumatic - https://www.amazon.ca/Plastic-Pneumat... 6mm air line - https://www.amazon.ca/SNS-Pneumatic-M... Air Regulator - https://www.amazon.ca/H-K-Pneumatic-R... 1/4" 12V DC, 2 Way, Normally Closed Pneumatic Solenoid - https://www.amazon.ca/Normally-Pneuma... 1/4" 12V DC Normally Open Pneumatic Solenoid - https://www.amazon.ca/Baomain-Electri... Machine Screws for N/O Solenoid - Not on website - M5 0.8-10