How to replace the Water Pump 2011-2017 Toyota Camry 💧

Find the parts used in the video on CarParts.com just there https://carparts.solutions/CAMRY ⚙️ NEEDED CARPARTS AND PRODUCTS Water pump : https://carparts.solutions/WaterPump_... Coolant : https://carparts.solutions/Coolant_CAMRY 💪 TIGHTENING TORQUES Water pumps bolts : 15 Ft-lbs 🛠 TOOLS The toolbox recommended by CARPARTS.COM to repair your Toyota Camry : https://carparts.solutions/ToolBox List of the tools we used to replace the water pump on a Toyota Camry : Hydraulic jack : https://carparts.solutions/FloorJack Jack stands : https://carparts.solutions/JackStands Fluid collector Plastic tube 13mm offset wrench Ratchet 12mm socket Big Flat head screwdriver Small crowbar Hammer Paper towel Sandpaper Compressed air Cloth Torque wrench : 20 to 250 Ft-lbs https://carparts.solutions/TorqueWren... 100 to 600 Ft-lbs https://carparts.solutions/TorqueWren... Don't forget to subscribe :    / @carpartscomofficial   🛻 COMPATIBLE VEHICLES The operation and tools displayed in the video should be available on the following vehicles : 2011 Toyota Camry 2012 Toyota Camry 2013 Toyota Camry 2014 Toyota Camry 2015 Toyota Camry 2016 Toyota Camry 2017 Toyota Camry 📽 🛠 USEFUL VIDEOS 🛠 📽 How to replace the Battery 2011-2017 Toyota Camry ⚡ :    • How to replace the Battery 2011-2017 Toyot...   How to jack your Toyota Camry safely :    • How to jack your Toyota Camry safely ? ⬆ 🚗   How to change the Coolant 2011-2017 Toyota Camry ❄️ :    • How to change the Coolant 2011-2017 Toyota...   How to replace the Serpentine belt 2011-2017 Toyota Camry 🛻 :    • How to replace the Serpentine belt 2011-20...   ⚠️ CARPARTS.COM'S INFOS In order to change the water pump, it is necessary to carry out a complete bleed of your cooling system. Finish tightening the bolts in staggered order using a torque wrench. Everyone's natural reflex is to take the water pump in hand and turn the pump pulley to check that this element is rotating correctly. But this is a serious mistake that can irreversibly damage the water pump. You need to immerse the pump in coolant, and to turn it around ten times. This prevents subsequent leaks, as the pump must never run dry. 🚨 DISCLAIMER This video is for entertainment purposes only. Carparts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area. 📚 CHAPTERS 0:00 Intro 0:10 Disconnect the battery 0:35 How to pull up your Camry 0:56 Bleed the coolant 1:39 Remove the serpentine belt 2:12 Remove the water pump 3:39 Clean the gasket surface 4:27 Prepare the water pump 5:20 Install the new water pump + tightening torques 6:01 Put the components back 6:15 Put your Camry back on the ground 6:51 Add coolant 7:09 Reconnect the battery