Back Seat Cover Installation - Seat Bottom Portion - Full Instructions

How to install your leatherette, neoprene or air mesh back seat covers from AutoHQ 1. Remove the seat bottom of back seat from vehicle. 2. Install the seat bottom cover. Note that the back seat cover comes in 2 pieces. Lay both pieces out side by side and the shorter of the 2 pieces with less curvature on the corners corresponds to the seat bottom. 3. Connect the straps with the clips on the underside of seat bottom and pull the excess slack tight. There are 5 vertical straps and 3 horizontal straps. The 5 vertical straps connect with the corresponding straps on the top and bottom. For the horizontal straps, criss-cross them, connecting the top one with the bottom one, and the center one straight across. 3. Note the location of the seat belt buckles and make opening. This can be done by either cutting an "X" and pushing down excess material into the gap once installed or cutting an access point out. Do not cut the binding. 4. Return the seat bottom to vehicle with cover installed. You can do it! Refers to AutoHQ's back seat covers found exclusively at these links: https://autohq.com/p-30-semi-custom-l... https://autohq.com/p-31-semi-custom-l... https://autohq.com/p-192-neoprene-dia... https://autohq.com/p-189-air-mesh-sea...