DIY Overarm Dust Collection Hood for Table Saw

My table saw has horrible dust collection, second only to my miter saw. I've been looking at buying an overarm dust collection hood but they're expensive and won't necessarily fit a small job site saw. I decided to DIY one out of plywood and acrylic. I struggled with the design for a long time but decided enough was enough and I needed to just start building. I'm happy with the outcome although I could probably make some improvements to the dust hood design. After using this version for a while I'll know exactly how to upgrade it later. T-bolts: https://amzn.to/489l5j1 T-bolt kit: https://amzn.to/3szV1x3 2.5” flexible dust hose: https://amzn.to/44WsL59 🖥️ Website: https://www.fangerwoodworking.com/ 🔨 Tool links (Amazon links are affiliate links which I may earn a commission from if items are purchased, however, they are not sponsored products): Safety Gear Micro jig narrow rip push block: https://amzn.to/3Nl97ZF Micro jig paddle push block: https://amzn.to/43Ic9ON Milescraft push stick: https://amzn.to/3NDlDoW ISOTunes ear protection: https://amzn.to/44aYpMd Measuring FastCap measuring tape: https://amzn.to/3qYM9Ao Setup blocks: https://amzn.to/3NFobCZ Sanding Bosch sander: https://amzn.to/3qVilEE Saws Bosch job site table saw: https://amzn.to/46t1nhl Bosch track saw: https://amzn.to/43RNS8T Joining wen biscuit joiner: https://amzn.to/3CGt8Fm Drilling Forstner Bit Set: https://amzn.to/3NGbMi8 Other auto vacuum switch: https://amzn.to/42SayEE 2P10 super glue and activator: https://amzn.to/3Pot7gU Bosch dust extractor: https://amzn.to/3PmF8Dk WEN air cleaner: https://amzn.to/3JoWj3B