Building a custom Autococker after anodizing (time-lapse)

Welcome to my Pyrococker assembly video! I just finished building this custom Autococker from the ground-up, so the entire process is shown in this video. The only thing left out was some pre-assembly of the roller trigger and roller sear, but otherwise everything is shown. I had to wait a day for the various threadlockers to fully cure, so I wasn't able to show the "first shot" like in my other assembly videos :( But you can see the completed marker shooting at the end! Marker specs: Nummech items: Full-length Pyrococker body #003 with matching front/back block Pyro project beavertail and bolt pin Nautococker slider frame with an extended 4-finger foregrip Telos roller trigger and sear Unilock standard feedneck Nummech detents Nummech cut-through fire project grip panels Internals and misc parts: Inception lower bore (hammer, valve) Inception pneumatics (LPR, GTR ram v2, UFC 3way v2) Vendetta bolt Lapco cocking knob Junkyard banjo screw Freak 16" that has a weird change, the back only has Freak milling on one side, and new jewel? where did that come from... The polishing and anodizing was done by Danilo Masueli from Stained Works anodizing.   / zdspbcom     / nummech-paintball-products-167842983288702   It's a long video, the music loops a few times. Music by: Synapsis - https://freemusicarchive.org/music/Sy... Tom Cascino / Broke for Free - http://brokeforfree.com/ - Licensed under CC BY-NC-ND 4.0