Schwintek In-Wall Slide-out Inverted Rebuild Kit V2

Learn how to rebuild an inverted Schwintek In-Wall Slide-out system with this detailed walkthrough from the Lippert Technical Training Institute. This video covers the inspection, removal, disassembly, component replacement, reassembly, timing, installation, and synchronization of an inverted Schwintek system. The procedure begins with safety precautions, required tools, and methods for supporting the slide-out during service. You'll learn how to remove the H-column and gear racks, inspect the H-column, torque shaft, coupler, spur gears, and gear racks, and identify components that may require replacement. The video also demonstrates how to replace the V-rollers, shoes, snap rings, rivets, and bearing blocks included in the rebuild kits. You'll see how to properly measure and cut replacement gear racks, install the bearing block assemblies, correctly position the spur gears and coupler, and retime the upper and lower gear racks. The final steps cover reinstalling the rebuilt system, verifying proper measurements and alignment, installing the motor, and re-synchronizing both sides of the slide-out for proper operation. The video also explains the importance of using the correct standard or inverted rebuild kit, as these components are not interchangeable. For more technical training and repair resources, visit the Lippert Technical Training Institute. Shop our store at https://www.lippert.com/rv-camping/ma... For technical resources and support, visit https://support.lci1.com/, and don’t forget to subscribe to our channel! #RVSlideOut #Schwintek #Lippert #SlideOut