How To Cut Lenses to Fit Your Frames

Subscribe - https://goo.gl/iAwSQc NOTE: This method is neither intended nor recommended for prescription or corrective lenses! This was easier than expected and since I had lenses on hand that were large enough, it went a lot faster than bringing them in and having an optician order new lenses and perform a custom cut for these frames. I liked these Prada VPR 23R frames from when I wore prescription eyeglasses so after getting Lasik surgery, I decided to use them as sunglasses. As a recovery diver, I have a lot of sunglasses that I've pulled off the bottom to use as lens donors but I wouldn't hesitate to buy an inexpensive pair of sunglasses to get the right donor lenses. Either way, just pick a pair with lenses large enough and then custom cut them as shown in the video. It was easy, fast and worked out well. To Get the Job Done: -The sander in the video: https://amzn.to/2XV1znz -A cheaper sander: https://amzn.to/33TlHKJ -Assorted sand paper: https://amzn.to/3kYjank -80 Grit Only Sandpaper: https://amzn.to/2DMopai -Tape to protect lenses: https://amzn.to/3kDpWju PROTECTIVE GEAR: -Face Masks: https://amzn.to/3D0zCiW -Safety Goggles: https://amzn.to/3fZQfNq -Safety Goggles (2-Pack): https://amzn.to/2PX2eR5 -Ear Protection Ear Muffs: https://amzn.to/3QOBMrq -Ear Plugs: https://amzn.to/3CZJHfR -Shop Gloves: https://amzn.to/3aGzAgV -Nitrile Gloves (6-mil): https://amzn.to/3awjyWQ Video Index: 0:05 The Frames I want to Use 0:20 Selecting the Donor Lenses 0:40 Removing Existing lenses 0:53 Apply Protective Tape to Donor Lenses 1:40 Tracing the Donor Lens 2:38 The Sander and Sand Paper 3:08 Sanding By hand 3:35 The 45 Degree Edge 4:20 Remove the Protective Tape → Become a ScubaMoto Subscriber - https://goo.gl/iAwSQc → If this video helped, please give a thumbs up and subscribe for future videos → As an Amazon Associate I earn from qualifying purchases at no extra cost to you. Win! → Business Inquiries email: scubamoto@outlook.com