Jerry Can Blow Mould at Trial | Handled Can Mold Running | AMAN

A jerry can blow mould at trial: the parison comes down, the mould closes, the blow pin goes in and a handled can drops out. 🏭 Jerry Can Blow Moulds – see the tooling & send your drawing: https://www.amanmachine.com/jerry-can... 📩 Get an exact quote within 24–48 hours: https://www.amanmachine.com/go/yt-jca... 📱 WhatsApp +1 773-386-2484: https://www.amanmachine.com/go/yt-jca... Filmed at the trial run: the can in the open mould, one mould half up close, then the full cycle from the parison coming down to the can dropping out. Want a blow mould for your own jerry can or handled container? Send us the drawing or a photo of your sample, and we'll come back with an exact quote within 24–48 hours. WHAT YOU SEE IN THIS VIDEO A handled jerry can in the open mould, from the front and from the side The two mould halves opening, the flash still on the can One mould half up close: the can shape and handle cut into the cavity The parison coming down between the open halves The mould closing on the parison The blow pin going down into the neck, and the clamp holding the mould shut The mould opening and the can dropping out, cycle after cycle CHAPTERS 0:00 The can in the mould 0:15 The mould halves 0:27 Parison into the mould 1:05 Blow pin and clamp 1:21 The can drops out 1:39 What to send for a quote To quote, send us a drawing, a 3D file or clear photos of the can from every side; the volume, the handle, the neck size and the can weight you are aiming for; the material, and whether you need auto-deflashing; and the machine it will run on, or the output you need. Also written as: jerry can mold, jerrycan blow mould, jerry can blow mold, handled container blow mould, extrusion blow mould Quote code: YT-JCANMOULD #JerryCanMould #BlowMould #AMAN