How to Configure a Pixhawk Quadcopter Using Mission Planner (ArduPilot)?

🎥 This video was recorded during the Drone Bootcamp organized by the Department of Electronics Engineering at IIT (ISM), Dhanbad, in collaboration with MeitY and SWAYAM. Components used in the drone are as follows: 1) S500 Multi Rotor Air PCB Frame with High Landing Gear and Power distribution board for FPV Quad-Copter. 2) 1045 Holybro Propellers - 4 pieces 3) T-Motors AIR 221611 (920kV BLDC Motor) 4) 14.8v 4 cell LiPo Battery 5200mAh 5) RadioLink SE100 GPS + stand 6) Pixhawk 2.4.8 Drone Flight Controller 7) T-Motor Air 20A ESC 8) FlySky FS-i6 2.4G 6CH PPM RC Transmitter With FS-iA6B Receiver 9) Screwdriver Kit 10) Battery Connectors 🚁 From learning the basics to assembling and flying a fully functional quadcopter, this experience was incredibly rewarding. Looking forward to more exciting journeys—stay tuned! ❤️‍🔥 #DroneBootcamp #uav #dronetechnology #UnmannedAerialSystems #DroneAssembly #PixhawkS500 #UAVElectronics #iitismdhanbad #meity #swayam #electronicsengineering