Hunter Fan, How To

I had a request on how to assemble a Hunter Coastal Breeze. This video applies to pretty much any 90's Hunter Fans including the Coastal Breeze, Summer Breeze, Mayfair, Studio Series, etc. Step 1: Push the wires through the downrod. Screw the downrod onto the motor. Tighten set screw. Step 2: Place the canopy onto the downrod assembly. Step 3: Slide the ball onto the downrod, place the pin in the downrod. Slide the ball into place on the pin, and tighten all set screws. You are now ready to hang the fan. Use the solid (round) hole on the canopy to hang the fan on the little hook on the mounting bracket to make wiring connections. If you do not have a hook, or it is missing, have someone hold the fan for you, or have something to set it on while making wiring connections. After wire connections are made, and all wire nuts are tight, take the fan off the little hook and, holding the canopy, align the two "open" key-hole slots on two screws already installed on the mounting bracket. Push up and twist to lock them into place. Put the remaining screw into the position where the solid (round) hole is and tighten all screws. Hold the motor housing and turn to engage the ball into the locked position, i.e. the slot on the ball is aligned with the little tab on the canopy. You can then install blades, not included on this video, but it's a pretty straight-forward procedure.