CMMT-MP | Commissioning with Allen Bradley PLC | Advanced Velocity control function block

The Festo tutorial is about commissioning the CMMT-MP Festo controller. This video shows you how to configure the CMMT-ST with Allen Bradley PLC using advanced velocity control function block. Chapters: 00:00 Title 00:20 Parts list, Products and software 00:26 Downloading the EDS file and the library file from the Festo website 01:09 Configuring the IP address of PLC 02:13 Creating New Project 02:46 Registering the EDS file 03:24 Configuring CMMT-ST. 03:56 Configuring the CMMT-ST project 05:06 Importing the library 05:55 Importing the function block 07:56 Configuring the extended process data 10:18 Basic functions with telegram 102 velocity drives festo EIP block. 12:22 Diagnostics. --- Application Note about this topic: https://www.festo.com/us/en/support-p... CMMT-ST Servo drive https://www.festo.com/us/en/support-p... --- Products shown in the video: 8163946 Servo drive CMMT-ST-C8-1C-MP-S0 Rev 03 8173466 Assortment of plugs NEKM-C-23 8181670 Motor cable NEBM-M17G12-EH-10-Q6N-LE12 8156171 Stepper motor EMMT-ST-42-L-RSB 549428 Gear Box EMGA-40-P-G3-SST-42 --- Questions or feedback? Contact us. https://www.festo.com/contact --- Festo website: Visit us. https://www.festo.com --- Festo Service: The channel for everything to do with service and support. Quickly and easily commission, configure, operate and repair Festo products. The tutorials from Festo Service will help you! --- Safety instructions: Before, during and after the work, all guidelines, rules and regulations applicable in your own country must always be observed. Installation (including software), in particular for demonstration purposes, repair and commissioning must only be carried out by qualified, trained and instructed specialist personnel and in accordance with the operating instructions for the products. All installations, maintenance and repair work must only be carried out when switched off. All energy supplies must be permanently interrupted. During the work, some protective equipment might be put out of service. These must be properly reinstalled immediately after completion of the work, put into operation and checked for function! It is imperative that safety instructions and the instructions for handling the product are fully read, understood and adhered to during the work before starting work! When working on the products, the applicable regulations regarding occupational health and safety technology as well as all specifications of the operating instructions and, if applicable, written repair instructions must be observed. If you have any questions or uncertainties, please contact Festo SE & Co. KG directly and do not continue the work until clarification.