Перейти к содержимому

BMW X5 G05 B58 Oil Change DIY | Oil & Filter Replacement

BMW X5 G05 DIY

0:00 / 0:00

BMW X5 G05 B58 Oil Change DIY | Oil & Filter Replacement

73 просмотра · 1 день назад
BMW X5 G05 DIY
1 подписчик
73 просмотра · 1 день назад
Looking to change the engine oil and oil filter on your BMW X5 G05? In this step-by-step DIY guide, I’ll show you how to perform an engine oil and filter change on a 2022 BMW X5 G05 sDrive40i with the B58 engine, following the BMW ISTA service procedure. This video covers the complete oil service process, including engine oil warm-up, oil filter removal and replacement, drain plug removal, O-ring and sealing ring replacement, proper torque specifications, engine oil refill, electronic oil-level measurement, leak inspection, and CBS oil-service reset. I've listed the important BMW ISTA specifications and service information below to save you some time. Hope this helps other G05 owners looking to service their own vehicles! -------------------------------------------------- [ 2022 BMW X5 G05 sDrive40i - Engine Oil Service Specs (ISTA) ] • Engine: B58B30M1 • Engine oil capacity with oil filter replacement: 6.5 L (approx. 6.9 US qt) • Recommended oil temperature before draining: Above 70°C (158°F) • Engine oil drain plug (M12 x 16): 25 Nm (18.4 lb-ft) ※ Renew the sealing ring. • Oil filter cap: 25 Nm (18.4 lb-ft) ※ Renew the oil filter and O-ring. ※ Lightly coat the new O-ring with fresh engine oil. ※ Make sure the new O-ring is installed in the correct groove on the filter cap. ※ Make sure the new filter snaps securely into the filter cap. -------------------------------------------------- [ ELECTRONIC OIL LEVEL CHECK ] After filling the engine with oil: • Reinstall and securely close the oil filler cap. • Make sure the vehicle is parked on a level surface. • Perform the electronic oil-level measurement. • Add oil only if required. Do not overfill the engine. -------------------------------------------------- [ CBS OIL SERVICE RESET ] • Press START/STOP 3 times to enter PAD mode. • Press and hold the trip-reset button for approximately 10 seconds. • Select ENGINE OIL from the service menu. • When “Reset possible” appears, press and hold the button again. • Confirm the reset. • Verify that “Reset successful” appears. -------------------------------------------------- [ USED ENGINE OIL ] Please recycle your used engine oil properly. Most auto parts stores or local recycling centers accept used motor oil. Check your local regulations and dispose of used oil and the used oil filter responsibly. -------------------------------------------------- [ DISCLAIMER ] The information contained in this video is for general informational and educational purposes only. Any DIY car repair or maintenance you perform is done at your own risk. I am not a professional mechanic, and I assume no liability for any property damage, injury, or loss incurred as a result of any of the information contained in this video. Always consult the factory service information for your specific vehicle and use proper tools and safety equipment before attempting any maintenance or repairs. BMW, X5, and ISTA are registered trademarks of BMW AG. This video is for informational and educational purposes only and is not affiliated with or endorsed by BMW. #BMWX5 #G05 #B58 #OilChange #BMWOilChange #DIY #BMWDIY #BMWG05 #sDrive40i #OilFilter #BMWRepair #CarMaintenance