I Put a DRS Suppressor on My FX Dynamic!!! Bad Idea?

I took the FX Dynamic out to test a 3D-printed suppressor designed specifically for the FX DRS. Since the threads match and it clears the over-the-barrel tank on the Dynamic just fine, I wanted to see how it handled on the bench. It wasn't clipping the baffles, but the accuracy completely fell off a cliff anyway. Between chasing wild grouping issues and losing audio mid-session, this run did NOT go to plan. With the heat pushing high 90s, I had to pack it in early, so this is Part 1. I'll be back out at first light tomorrow morning for Part 2 to tear down the tune, check alignment, and figure out why this setup is choking. Have you ever run cross-model 3-D suppressors on your FX rigs? Drop your theories in the comments, and don't forget to subscribe for the Part 2 fix! #FXDynamic #AirgunTuning #FXAirguns #AirgunNation #3DPrinted #Suppressor #SlugShooter #BenchrestAirgun Mantis scope (4-12x40mm) https://amzn.to/ 4eZvm6B Mantis scope (3-9x40mm) https://amzn.to/ 3QFvtLm Scope rings and mounts: https://amzn.to/ 4XJCxHn Stick on targets: https://amzn.to/4gGfQXC Filament used to 3-D print the suppressors and containers https://amzn.to/3QAKWwf Death grip aluminum tripod https://amzn.to/ 4y2Clms 1L buddy bottle: https://amzn.to/44aBlda DIN valve fill adapter: https://amzn.to/4v83MZG Laser rangefinder| https://amzn.to/4gs87Bw *I am an Amazon affiliate and gain a commission from qualifying purchases **